finalover90 (796290), страница 5
Текст из файла (страница 5)
Which suggestion shouldthe administrator adopt to ensure the success of this project?A single-mode optical fiber cable can support Gigabit Ethernet over the 900 meter distance.*A combination of UTP, repeaters, and multimode optical fiber will reach 900 meters with Gigabit Ethernet.Ethernet cannot be used over these distances and another technology such as ATM should be used.The best that can be done over a 900 meter run is full-duplex Ethernet over UTP cable operating at 100 Mbps.UTP can be used, but for Gigabit Ethernet over a 900 meter distance, the cable must be Category 5e cable .(this question (no 43) also not have in my final exam***************************************************************************44.
Refer to the exhibit. What is the order of the TCP/IP Protocol Data Units as data is moved as indicatedthrough the OSI model?data, segments, frames, packets, bitsdata, packets, segments, frames, bits*data, segments, packets, frames, bitsdata, packets, frames, segments, bits********************************************************************************45 Which technologies are considered to be WAN technologies? (Choose two.)Ethernet*DSLToken Ring*Frame RelayFDDI****************************************************************************************46 Which statement describes a star topology?Each host in the network is connected to a backbone cable that is terminated at both ends.*Each host is connected to a hub or switch, either of which acts as a central point for all network connections.Each host is directly connected to two other hosts to form a long chain of hosts.Each host has a connection to all other hosts in the network.*****************************************************************************47.
Refer to the exhibit. A network administrator is testing a connectivity issue in the network. The administratordiscovers that host A cannot communicate with host B, host C, or RouterA. A ping command on host A to127.0.0.1 succeeds. The NIC link indicator on host A is illuminated. Temporarily, the administrator removes thecable from host A and uses the LAN cable from host B to connect from host A to port 1 on the switch.
Whileusing the substitute cable, host A can communicate with host C and RouterA. At which layer of the OSI modelwas the problem occurring?sessiontransportnetworkdata link*physical************************************************************************48. Refer to the exhibit. What type of cable connects the two routers together without any intermediary device?consolerollover*crossoverstraight-through******************************************************************49 Refer to the exhibit. What is an advantage of using this type of topology?This type of network has redundancy.No collisions occur on this type of network.*Network communication continues in the event of a break.A central device on the network controls communication on this type of network.(this question NO(49) also don’t have**********************************************************50.Refer to the exhibit.
Host A is being manually configured for connectivity to the LAN. Which two addressingscheme combinations are possible configurations that can be applied to the host for connectivity? (Choose two.)*Address - 192.168.1.82 Gateway - 192.168.1.65*Address - 192.168.1.70 Gateway - 192.168.1.6551.Which of the following devices extend a collision domain? (Choose two.)*hub*repeater52.A technician needs to connect a FastEthernet port from a router to a FastEthernet port on a switch. Thegraphic shows the RJ-45 cable ends for a patch cable.
What result can be expected if this cable is used for thelink?*The cable will be able to pass traffic between the devices..
![](https://s.studizba.com/z.php?f=/templates/si/i/noavatar.png&w=100&h=100&t=1"){kind=avatar}
