finalover90 (796290), страница 4
Текст из файла (страница 4)
Refer to the exhibit. What must be configured on Host B to allow it to communicate with the Host C?(Choose three.)the MAC address of RTA router interface connected to Switch 1*a unique host IP addressthe IP address of Switch 1*the default gateway addressthe MAC address of Host C*the subnet mask for the LAN****************************************************************************21. Refer to the exhibit. The connections in the exhibit are labeled A through E.
Which of these indicate WANlinks? (Choose three.)link A*link B*link C*link Dlink E******************************************************************************************22 Refer to the exhibit. Which type of UTP cable should be used to connect Switch1 to Switch2?rolloverconsole*crossoverstraight-through*****************************************************************************23/A user initiates three simultaneous FTP connections from the local host to the same FTP server.
Which OSIlayer is responsible for establishing and managing these different FTP connections?application*sessiontransportnetworkdata link******************************************************************************24. Which layer of the OSI model defines the process of adding the source and destination IP address to a datapacket?transport*networkdata linkphysical*************************************************************************25. Refer to the exhibit.
What is the purpose of the highlighted address?*It allows the NIC to communicate with other devices on the same network.It identifies which part of the IP address is to be considered the network portion.It provides an address to which all packets that do not have a specific route are sent.It uniquely identifies the NIC to the free token that is passed on the Ethernet network.******************************************************************************************26. What is the correct number of usable subnetworks and hosts for the IP network address 192.168.99.0subnetted with a /29 mask?6 networks / 32 hosts14 networks / 14 hosts*30 networks / 6 hosts62 networks / 2 hosts*****************************************************************************************27.
Refer to the exhibit. Which type of cabling should be used at each of the connection points shown?A-crossoverB- straight-throughC-straight-throughD-fiberE-straight-throughA-crossoverB-crossoverC-straight-throughD-fiberE-crossover*A-straight-throughB-crossoverC-straight-throughD-fiberE-straight-throughA-fiberB-crossoverC-straight-throughD-crossoverE-straight-throughA-straight-throughB-crossoverC-crossoverD-fiberE-straight-throughA-crossoverB-crossoverC-straight-throughD-fiberE-straight-through******************************************************************************28.
Which combination of network id and subnet mask correctly identifies all IP addresses from 172.16.128.0through 172.16.159.255?172.16.128.0 255.255.255.224172.16.128.0 255.255.0.0172.16.128.0 255.255.192.0*172.16.128.0 255.255.224.0172.16.128.0 255.255.255.192*********************************************************************29.Which binary number is a representation of the decimal number 248?1110100011110100*1111100011111010*********************************************************************30 What are three characteristics of the TCP protocol? (Choose three.)exchanges datagrams unreliablyis used to send IP error messages*forces the retransmission of unacknowledged packets*creates a virtual session between end-user applicationscarries the IP address of the destination host in the TCP header*is responsible for breaking messages into segments and reassembling them at their destination*****************************************************************************31.Refer to the exhibit.
A company needs to attach workstation E at a point 150 meters from an existing hub.What device should be placed at location D to allow the new host to connect to the network with the leastamount of latency?routerswitchbridge*repeater*****************************************************************************32. Refer to the exhibit. An instructor in the network class has given the students the network diagram and asksthe students to select the appropriate network devices.
The goals are to provide a collision-free LANenvironment and to provide Internet connectivity. What is the correct design?Replace Box 1 with a hub and Box 2 with a router.Replace Box 1 with a router and Box 2 with a bridge.*Replace Box 1 with a Layer 2 switch and Box 2 with a router.Replace Box 1 with a router and Box 2 with a Layer 2 switch.Replace Box 1 with a bridge and Box 2 with a Layer 2 switch.******************************************************************************************33.A simplified CAM table for Switch1 is shown in the exhibit. If host A sends a frame with a destination MACaddress of 66C, how does the switch process this frame?The switch drops the frame.The switch sends the frame out port 3.The switch sends the frame out ports 1, 2, and 4.*The switch sends the frame out ports 2, 3, and 4.The switch sends the frame out ports 1, 2, 3, and*****************************************************************************34.Refer to the exhibit.
A newly hired technician has a task of terminating CAT 5 UTP cables. The networkadministrator visually examined the cables the technician terminated. Some of the cables have connectors asshown in the exhibit. What should the network administrator explain to the technician about the cables?Both cables are acceptable.*The cable in Graphic A will produce more crosstalk.The cable in Graphic A should be used in the more critical network segments.The cable in Graphic A is preferred because it will be easier to crimp the connector.********************************************************35 Which of the following increases the potential for a collision to occur?the use of an active hub instead of an intelligent hubthe use of an intelligent hub instead of an active huba reduction in the number of devices attached to the hub* an increase in the number of devices attached to the hub*****************************************************************************36.
Which type of address is 223.168.17.167/29?host addressmulticast addressbroadcast address*subnetwork address*****************************************************************37. Refer to the exhibit. The internetwork in the exhibit has been assigned the IP address 172.20.0.0. Whatwould be the appropriate subnet mask to maximize the number of networks available for future growth?*255.255.224.0255.255.240.0255.255.248.0255.255.252.0255.255.254.0255.255.255.0***********************************************************38Workstation A sends data to workstation B. What will have to be altered as the data passes through the router?(Choose two.)*Layer 1 bit pattern*Layer 2 framesLayer 3 packetsLayer 4 segmentsLayer 5 -7 data***********************************************************************39 What should a network administrator consider when migrating to Gigabit Ethernet architecture from FastEthernet? (Choose three.)*Existing NICs might need to be upgraded.*Existing switches might need to be upgraded.Existing NICs must support half-duplex mode.Existing UTP wiring must be replaced with fiber.*Existing UTP must be tested for CAT 5e compatibility.Existing network topology must support shared media.******************************************************************************40 What type of routing is it when the network administrator manually configures a route?*staticdynamicinteriorexterior*************************************************************41.
Refer to the exhibit. A network administrator attempts to increase the available bandwidth for workstation Aby setting the NIC to full-duplex mode. After the configuration is changed, there are increased collisions anderrors occurring. Why is this occurring in the network?The NIC is no longer detecting collisions.The switch will not support full-duplex mode.*The hub will be continually producing a jam signal.The cabling will not support bidirectional transmissions.************************************************************************42.
Refer to the received frame in the exhibit. In what two ways is the information from the received frame usedby a switch? (Choose two.)192.168.10.5 is used to create an ARP request.192.168.10.5 is used to build the forwarding table.1234.5678.1abc is stripped from the frame header.*192.168.10.11 is left intact as the frame is forwarded.The switch compares 192.168.10.11 to the addresses in the routing table to make the forwarding decision.*To make the forwarding decision, the switch looks in its switch table for address aaaa.bbbb.cccc.***********************************************************43. An IT administrator desires to install a Gigabit Ethernet link between the two buildings shown in the exhibit.Conflicting suggestions have been given to the administrator from a variety of sources.
![](https://s.studizba.com/z.php?f=/templates/si/i/noavatar.png&w=100&h=100&t=1"){kind=avatar}
