CCNA_2_UPD (1130967), страница 11
Текст из файла (страница 11)
What happens to a static route entry in a routing table when theoutgoing interface is not available?The route is removed from the table.19. The routers in the diagram use the subnet assignments shown. What isthe most efficient route summary that can be configured on Router3 toadvertise the internal networks to the cloud?192.1.1.0/2520. Refer to the exhibit. How will packets destined to the 172.16.0.0network be forwarded?Router1 will perform recursive lookup and packet will exit S0/0.21. A router has one static route to each destination network. Which twoscenarios would require an administrator to alter the static routes that areconfigured on that router? (Choose two.)The destination network no longer exists.A topology change occurs where the existing next-hop address or exit interface isnot accessible.22.
Refer to the exhibit. Given the output in the exhibit, how would a clockrate be determined for this link?The rate configured on the DCE determines the clock rate.23. Refer to the exhibit. Which set of commands will configure static routesthat will allow the WinterPark and the Altamonte routers to deliver packetsfrom each LAN and direct all other traffic to the Internet?WinterPark(config)# ip route 0.0.0.0 0.0.0.0 192.168.146.1Altamonte(config)# iproute 10.0.234.0 255.255.255.0 192.168.146.2Altamonte(config)# ip route 0.0.0.00.0.0.0 s0/124. Refer to the exhibit.
What two commands are required to provideconnectivity between the 192.168.1.0 and 10.0.0.0 networks withoutrequiring recursive lookup? (Choose two.)A(config)# ip route 10.0.0.0 255.0.0.0 s 0/1/0B(config)# ip route 192.168.1.0 255.255.255.0 s 0/0/0comments (0)TOP04:23CCNA 2:Module 1POSTED BY ADMINOptions With Highlight Colours are Correct Answer1. If a router cannot find a valid configuration file during the startupsequence, what will occur?The router will prompt the user for a response to enter setup mode.2. Refer to the exhibit.
The network administrator has configured the routerwith the interface IP addresses shown for the directly connected networks.Pings from the router to hosts on the connected networks or pings betweenrouter interfaces are not working. What is the most likely problem?The interfaces must be enabled with the no shutdown command.3. Refer to the exhibit. What can be concluded from the routing tableoutput in the exhibit? (Choose two.)Стр.
24 из 2701.04.2009 0:45CISCO CCNA Certifications: CCNA 2 UPDATEDfile:///D:/botalka/%D1%81%D0%B8%D1%81%D1%8C%D0%BA...The FastEthernet0/0 and Serial0/0/0 interfaces of this router were configured withan IP address and the no shutdown command.An IP packet received by this router with a destination address of 198.18.9.1 will beforwarded out of the Serial0/0/0 interface.4.
Refer to the exhibit. The frame shown in the exhibit was received by therouter. The router interfaces are operational. How will the router processthis frame? (Choose two.)The router will change the frame type to one supported by the WAN link beforeforwarding the frame.The frame was received on the Fa0/0 interface of the router and will be switched tothe S0/0/0 interface.5. Passwords can be used to restrict access to all or parts of the Cisco IOS.Select the modes and interfaces that can be protected with passwords.(Choose three.)VTY interfaceconsole interfaceprivileged EXEC mode6. Which two statements correctly describe the components of a router?(Choose two.)ROM contains diagnostics executed on hardware modules.Flash memory does not lose its contents during a reboot.7.
Refer to the exhibit. After host 2 is connected to the switch on the LAN,host 2 is unable to communicate with host 1. What is the cause of thisproblem?The subnet mask of host 2 is incorrect.Host 1 and host 2 are on different networks.The switch needs an IP address that is not configured.The router LAN interface and host 1 are on different networks.The IP address of host 1 is on a different network than is the LAN interface of therouter.8. Which are functions of a router? (Choose three.)packet switchingsegmentation of broadcast domainsselection of best path based on logical addressing9. Refer to the exhibit.
All routers have a route in its routing table to eachnetwork that is shown in the exhibit. Default routes have not been issuedon these routers. What can be concluded about how packets are forwardedin this network? (Choose two.)If RouterA receives a packet that is destined for 192.168.3.146, it will be forwardedout interface S0/0/1.If RouterB receives a packet that is destined for 10.5.27.15, it will be forwarded outinterface S0/0/1.10.
The serial connection shown in the graphic needs to be configured.Which configuration commands must be made on the Sydney router toestablish connectivity with the Melbourne site? (Choose three.)Sydney(config-if)# ip address 201.100.53.2 255.255.255.0Sydney(config-if)# no shutdownSydney(config-if)# clock rate 5600011.
Refer to the exhibit. What can be concluded from the output of therunning-configuration of a router?The commands that are displayed determine the current operation of the router.12. Refer to the exhibit. Host A pings host B. When R4 accepts the ping intothe Ethernet interface, what two pieces of header information are included?(Choose two.)destination IP address: 192.168.10.134destination MAC address: 9999.DADC.123413.
What is the outcome of entering these commands?R1(config)# line vty 0 4R1(config-line)# password check123R1(config-line)# loginsets the password to be used for connecting to this router via Telnet14. Which of the following is the correct flow of routines for a routerstartup?load bootstrap, load IOS, apply configuration.15. What three processes does a router execute when it receives a packetfrom one network that is destined for another network? (Choose three.)decapsulates the Layer 3 packet by stripping off the Layer 2 frame header.uses the destination IP Address in the IP header to look up the next-hop address inthe routing table.encapsulates the Layer 3 packet into the new Layer 2 frame and forwards it out theexit interface.16.
The network administrator needs to connect two routers directly viatheir FastEthernet ports. What cable should the network administrator use?cross-over17. Which two statements describe characteristics of load balancing?Стр. 25 из 2701.04.2009 0:45CISCO CCNA Certifications: CCNA 2 UPDATEDfile:///D:/botalka/%D1%81%D0%B8%D1%81%D1%8C%D0%BA...(Choose two.)Load balancing allows a router to forward packets over multiple paths to the samedestination network.Unequal cost load balancing is supported by EIGRP.18. What information about the router and its startup process can begathered from the output of the show version command? (Choose three.)the last restart methodthe configuration register settingsthe location from where the IOS loaded19.
Which interfaces in the exhibit could be used for a leased line WANconnection? (Choose two.)1420. From what location can a router load the Cisco IOS during the bootprocess? (Choose two.)TFTP serverFlash memory21. A network administrator has just entered new configurations intoRouter1. Which command should be executed to save configuration changesto NVRAM?Router1# copy running-config startup-config22.
What is the default sequence for loading the configuration file?NVRAM, TFTP, CONSOLE23. What header address information does a router change in theinformation it receives from an attached Ethernet interface beforeinformation is transmitted out another interface?the Layer 2 source and destination address.comments (0)TOP|Newer Posts Older Posts| |HomeSubscribe to: Posts (Atom)mobile-spy.ruОбратная связь - Реклама от GoogleVMware / Xen NetworkVyatta - Open Networking Router,Firewall,VPN, IPS & morewww.vyatta.comUSA Mikrotik DistributorFull inventory, fast shipping Competitive prices & supportwww.roc-noc.comWe Buy & Sell CiscoSupplier of Cisco Hardware Call Sales - +44 (0) 8700 119930www.continuationnetworks.co.ukGOeuroSourceIT.comEurope's Dynamic I.T.
Trading Site! For Cisco, SUN, HP, 3COMetcwww.goeurosourceit.comСтр. 26 из 27Advertise HereAdvertise Here01.04.2009 0:45CISCO CCNA Certifications: CCNA 2 UPDATEDСтр. 27 из 27file:///D:/botalka/%D1%81%D0%B8%D1%81%D1%8C%D0%BA...Имеется информация, что этот сайт атакует01.04.2009 0:45.
![](https://s.studizba.com/z.php?f=/templates/si/i/noavatar.png&w=100&h=100&t=1"){kind=avatar}
