CISCO CCNA Certifications_ CCNA 3_Module 6 (1130904), страница 2
Текст из файла (страница 2)
in which situation could individual router physicalinterfaces be used for InterVLAN routing, instead of arouter-on-a-stick configuration?a network with more than 100 subnetworksa network with a limited number of VLANsa network with experienced support personnela network using a router with one LAN interface20. Refer to the exhibit. Switch1 is correctly configuredfor the VLANs that are displayed in the graphic. Theconfiguration that is shown was applied to RTA to allowfor interVLAN connectivity between hosts attached toSwitch1. After testing the network, the administratorlogged the following report:Hosts within each VLAN can communicate with each other.Hosts in VLAN5 and VLAN33 are able to communicate with eachother.Hosts connected to Fa0/1 through Fa0/5 do not haveconnectivity to host in other VLANs.Why are hosts connected to Fa0/1 through Fa0/5unable to communicate with hosts in different VLANs?The router interface is shut down.The VLAN IDs do not match the subinterface numbers.All of the subinterface addresses on the router are in thesame subnet.The router was not configured to forward traffic for VLAN2.The physical interface, FastEthernet0/0, was not configuredwith an IP address.POSTED BY SNOWANGEL AT 05:35LABELS: CCNA 3 UPDATED1 COMMENTS:Laca said...The 2nd answer for 14 is:The command is used in the configuration of router-on-a-stickinter-VLAN routing.http://cisco-ccna-certifications.blogspot.com/2008/08/ccna-3module-6.html[10/29/2008 2:50:46 PM]CISCO CCNA Certifications: CCNA 3:Module 6The 2nd answer for 15 is:Both of the directly connected routes that are shown will share thesame physical interface of the router.27 OCTOBER 2008 16:36Post a CommentNewer PostHomeOlder PostSubscribe to: Post Comments (Atom)http://cisco-ccna-certifications.blogspot.com/2008/08/ccna-3module-6.html[10/29/2008 2:50:46 PM].
![](https://s.studizba.com/z.php?f=/templates/si/i/noavatar.png&w=100&h=100&t=1"){kind=avatar}
